Q & A | Censtry

All Categories

Embedded DIY maker DSP technology FPGA/CPLD College area Linux system

MCU application STM32 MCS 51 MSP430 MCU AVR MCU PIC MCU

Circuit design Power technology Electronic Component RF / ICT Sensing control EMC/EMI

PCB Technology / Design / Customization Proteus simulation Labview simulation EDA circuit tool

Consumer Electronics Auto electronics Industrial Electronics Other applications Medical electronics LED application

Raspberry Pi Arduino Bananapi NanoPi MicroPython Seeed Intel Development board Linkit Smart 7688 Galileo/Edison Freescale FRDM Rayeager PX2 Waveshare IntoRobot Beaglebone Black Firefly open source hardware ZLG Orange Pi DFRobot WRTnode TigerBoard

Maxim technology NXP technology ON technology WIZnet network technology TI technology ADI technology Other original technology Rohm technology Cypress technology EPSON technology Rochester TOSHIBA technology LITEON technology Micron technology Preferred materials

Hot Q&A

How to determine the driving capability of the signal? [Details]
Is this power circuit charging or discharging? [Details]
When the STM32F030C8 external io port interrupt level is kept at 1.2V, the interrupt is always triggered and cannot come out. [Details]
Damaged half-bridge drive circuit components. [Details]
What caused the burning of the TVS at the power input terminal? [Details]
How to control the power supply of two power supplies. [Details]
What is the function of the diode between these two operational amplifiers? [Details]
What is the difference between high-end detection and low-end detection when detecting current? [Details]

All Categories

Hot Q&A

Select Your Location