What is the difference between STC11F02 and STC11F02E in programming?

Original factory

May 05, 2019 by Terry Wells 2997

The previous batch of STC11F02 about 300 pieces, at least 100 pieces of could not be programmed, I try it by many methods but all failed .

Urgently I bought a batch of STC11F02E back, view the difference between the two data , I fought the STC11F02E has 2K EEPROM, but STC11F02 does not, it should be available, but still can not write into the program.

Pls help me what’s problem.

All Comments

Lani Posted on May 5, 2019

There is no problem with the programmer, and a total of 4 burners cannot be programmed.
The film that was previously burned can be removed from the other board and soldered on the current board to burn it, indicating that the board is good.
I think the problem is the film, because there is too much can not be burned at once! There is no problem with the programmer, and a total of 4 burners cannot be programmed.
The film that was previously burned can be removed from the other board and soldered on the current board to burn it, indicating that the board is good.
I think the problem is the film, because there is too much can not be burned at once!

You need to log in to reply. Sign In | Register

Toto Stoev Posted on May 5, 2019

I have never encountered such problems, but someone had said on internet:
"Note that the write enable flag WRTD of the configuration word EEPROM cannot be cleared to 0."
I don't know exactly what it mean, welcome to share after you solve it.

You need to log in to reply. Sign In | Register

Petya Simeonova Posted on May 5, 2019

Pay attention to the prompt when downloading, mainly to see if you want to power-on reset of the microcontroller, the download speed is faster than the general-purpose programmer. Be sure to select the 'Download' button first, then power-on reset the MCU (first power off), instead of powering up first, the power-on can not detect the legitimate download command stream, the MCU will run the user program directly. ”

You need to log in to reply. Sign In | Register

Brigitte Penzkofer Posted on May 5, 2019

The problem is switching power supply, there is interference at the moment when the switching power supply turned on. The switching power supply is always on, and the power supply terminal block can be plugged in normally!

You need to log in to reply. Sign In | Register