Questions

• Recommend
• Latest

• 0Reply
  When the STM32F030C8 external io port interrupt level is kept at 1.2V, the interrupt is always triggered and cannot come out. STM32

  March 17, 2021 by Matthew 1889
• 0Reply
  STM32SPI1 debugging runs at full speed without any waveform. STM32

  February 1, 2021 by Daley 1193
• 0Reply
  STOP mode serial communication has a high bit error rate. STM32

  January 29, 2021 by Irena 1176
• 0Reply
  How to configure the STM32F030SPI port? STM32

  January 14, 2021 by Chandler 1174
• 0Reply
  STM32F030 has low power consumption and high current in stop mode. STM32

  January 5, 2021 by Caius 1341
• 0Reply
  Can FSMC be used as external storage? STM32

  January 4, 2021 by Mercy 1243
• 0Reply
  How does STM32F1CUBE use partial remapping? STM32

  December 24, 2020 by Diane 1151
• 0Reply
  STM32 beginners. STM32

  December 22, 2020 by Nena 1173
• 0Reply
  The stm32F449 test code compilation cycle is too long. STM32F4

  December 21, 2020 by Jina 1272
• 0Reply
  STM32F103 cannot wake up when it enters STOP mode during interrupt. STM32

  December 21, 2020 by Gwyneth 1350
• 0Reply
  The DAC channel of stm32 cannot be output. STM32

  December 17, 2020 by Lola 1215
• 0Reply
  After the project based on stm32f103 is transplanted to stm32f051, the online hardware simulation stm32f051 program cannot run. STM32

  December 10, 2020 by Henrik 1314
• 0Reply
  When the STM32F103RFT6 PC3 is used as an input, the PC3 mode is set to pull-up input. When the MCU reads out, the results are all high. STM32

  December 10, 2020 by Margo 1173
• 0Reply
  When STM32F103C8T6 is doing three-resistance sampling, the interrupt enters two consecutive interrupts. STM32

  December 10, 2020 by Hakeem 1120
• 0Reply
  STM32 does a dot matrix LCD program and the data area bursts, and I need to solve it. LCD

  December 3, 2020 by Franco 1046
• 0Reply
  How does STM32F1CUBE use partial remapping? STM32

  December 2, 2020 by Bowen 1083
• 0Reply
  stm32f4discovery audio acquisition and FFT calculation frequency is very large. STM32

  November 25, 2020 by Lennox 1101
• 0Reply
  About the serial communication between STM32 and zigbee module. STM32

  November 25, 2020 by Miya 1169
• 0Reply
  Stm32f427 replaces stm32f207 with 100 feet, and the serial port download jlink simulation encounters problems. Stm32f427

  November 24, 2020 by Kelli 1291
• 0Reply
  The IO port of STM32F103 is connected to a 5V level. What if the IO port is used as a data port with both output and input? STM32F103

  November 19, 2020 by Arman 1344