• Sign In / Register
  • Language
    • English
    • Deutsch
    • Française
    • Español
    • Português
    • Italia
    • Русский
    • 日本語
    • 한국어
    • 简体中文
    • 繁體中文

The measurement method of PCB wire width.

  • February 3, 2021
  • 148

This test does not cause any damage to the product, so when you test it depends on your mood.

PCB.png

First of all, we need to know whether our purpose is to measure whether the width of the wire obtained after production is consistent with the original circuit design requirement on the customer's circuit pattern.


Secondly, we need to know what kind of equipment we need for testing. These equipment include a scaled microscope (X50) that can capture 0.001". The microscope can be placed perpendicular to the surface of the board. Of course, a projection magnifier is the best .


Finally, the most important step is the entire process of testing. These processes mainly have three steps.


1) Prepare the test board: We can use the naked eye to select the test area, and divide it into 0.500" long straight or curved areas, and then we number them.


2) Test evaluation: Check the width of each 0.500" curve area, and record the results of the test. Defects like some isolated gaps or protrusions are acceptable in principle, but they must be identified and measured.


3) Calculation: We take the width of the middle point between the highest point and the lowest point of each side as the average width of the parallel side wires. We should take the average of the three measurement results in each area to measure.


Select Your Location