stc15w201s does not need an external crystal oscillator and reset circuit, so I did not add it. I just burned it with the chip and then burned on the board with an LED light on each port. It prompts that the programming is successful. Re-power on and find that the program does not run. All pins are high. The default options of the burning software are all simple. The P3 port is 0x00 or p3.0=0. All of them don’t run the single-chip microcomputer. They are the same. Anyone knows the possible reason. Please help me. Thank you!
Rosemarie Posted on November 27, 2020
I have also encountered this situation, my reason is that the crystal oscillator is broken. . . You can try it.
Kalie Posted on November 27, 2020
If the STC MCU does not use an external crystal oscillator, it seems that it needs to be set in the programming software when programming.
Shalom Posted on November 27, 2020
Otherwise, just take a look at the manual of this chip, maybe you can find the answer from the manual, or else your program is not well written.
Margo Posted on November 27, 2020
Have the watchdog been cleared? In addition, it is best to use an oscilloscope to see the pin status. If the chip is constantly reset, the multimeter may not be able to see the problem.
